High speed injection valve
Shenzhen Xinghua Zhizao Technology Co., Ltd. specializes in the production of dispensing machine, filling machine, in Shenzhen, Dongguan, Guangzhou has R & D center and production base. Hotline :18922514695!
HW9830 Jet valve performance parameters
Minimum driving pressure
0.6 MPa
Maximum operating frequency
250cycles/s
Optimal feeding pressure
0 to 0.3Mpa
Minimum point diameter
The 0.2 mm
Adaptable glue range
0~200000 Cps
Overall dimension
155 mm×125 mm×30 mm
weight
600 g
Feed assembly
Stainless steel Luhr connector cartridge (standard)
Flip joint feed pipe (optional)
Fluid tank growing side feed (optional)
Can be connected to cylinder specifications
3CC, 5CC, 10CC, 30CC, 55CC
Feeder pipe specifications
4 divided, 6 divided
Main valve body
Stainless steel
Fluid cavity canal
Stainless steel
Firing pin assembly
Special high strength material + SUS303
Nozzle assembly
Special high strength material
Fluid seal ring
PTFE+SUS 304
Gas seal ring
polyurethane
Other O-rings
Nitrile butadiene rubber
Solenoid valve
24V (DC) 5W
Heating block
6061 AL anodized
Heating tube
24VDC or 220VAC 80W
Maximum heating temperature
150 ℃
* Note: The above HW9830 injection valve performance parameter values are obtained under specific pressure and fluid parameter conditions. In practical applications, it needs to be determined according to the actual glue characteristics and specific measurement conditions.
: In actual application, it should be adjusted according to the actual glue characteristics, but the maximum feeding pressure should not exceed 0.5Mpa, otherwise it will affect the status of the moving parts inside the valve body;
